Chardon Plumbing, Heating & Cooling

Responded to service call for gas furnace repeatedly shutting down with alternating red/green flash codes indicating flame sensor issues. Inspection revealed severe corrosion and rust damage throughout the unit, particularly on metal components and base pan. Cleaned flame sensor to restore proper operation, but noted significant deterioration that may require future replacement.

Identified and repaired water leak at connection point between water heater tank and shut-off valve in trailer home. Inspection revealed deteriorated insulation and damaged material surrounding the plumbing components, with leak occurring at the base of the trailer where it meets the skirting. Replaced affected fittings and ensured proper connection of PVC piping to resolve the issue.

Inspected boiler system in mechanical room and found unit completely non-operational. Visual examination of primary distribution piping and crawlspace access revealed significant deterioration requiring full replacement. Documented condition with photographs and recommended immediate replacement due to catastrophic failure.

Performed heating maintenance on one prepaid system under membership agreement. Conducted electrical diagnostics using Fieldpiece SC440 multimeter, measuring voltage and amperage parameters. Second system identified as requiring membership signup per customer's renewal agreement.

Responded to emergency service call after city water shut-off incident caused valve damage. Replaced broken valves in basement utility room plumbing system, which included work on the main water supply line with manual shut-off valves. Restored proper water flow and pressure regulation, ensuring functional plumbing system with appropriate shut-off capability.

Performed initial assessment of heating system following lead from Jeff. Evaluated existing furnace and ductwork configuration, noting silver foil-wrapped ducts connected to PVC venting. Discussed potential water heater replacement options with customer. Documented current installation conditions, including exterior venting and winter weather considerations that may impact equipment selection and installation requirements.

Inspected residential plumbing system, focusing on two primary issues: 1) In-Sink-Erator garbage disposal showing signs of wear and debris buildup requiring maintenance, and 2) water heating system in basement consisting of a standard tank water heater connected to water treatment equipment (likely softeners/filtration systems). Performed diagnostic assessment of both systems to determine necessary service requirements.

Performed diagnostic assessment on client's water treatment system due to reported water quality issues and air in lines. Conducted electrical measurements using Klein Tools HVAC digital clamp meter to verify proper operation of system components. Inspected dual-tank filtration system with PVC plumbing configuration and pressure tank, identifying potential sources of air infiltration in well supply line.

Diagnosed customer's no heat complaint on 10+ year old gas furnace. Performed visual inspection with digital camera revealing significant corrosion in internal components. Identified frost buildup on copper/brass fitting indicating refrigerant leak or condensation issue. Confirmed blower motor failure as customer suspected, requiring replacement to restore proper system operation.

Responded to call from Joseph Dugan regarding kitchen sink drainage issue. Upon inspection, found clogged drain system connected to garbage disposal unit. Successfully cleared blockage in the PVC piping network under the sink, restoring proper water flow and functionality to the kitchen drain system.

Responded to lead regarding 1994 Carrier furnace exhibiting high carbon monoxide levels. Conducted full inspection of existing HVAC system including ductwork, vents, and mechanical room components. Presented replacement options to customer due to safety concerns with aging equipment.

Returned to install OEM coil temperature sensor as previously sold by Sam. Upon arrival, observed excessive ice and frost buildup throughout the evaporator coil assembly and refrigerant lines, indicating sensor failure. Removed access panel, disconnected electrical connections, replaced defective temperature sensor, and restored proper system operation.

Responded to no-heat service call for 1995 Carrier furnace that was circulating air but failing to ignite. Performed gas pressure testing using dual port manometer, which revealed pressure readings of 323/-324, indicating significant pressure imbalance preventing proper combustion. Adjusted gas valve to manufacturer specifications, cleaned flame sensor, and verified proper ignition sequence, restoring heat function.

Responded to a gas leak complaint involving a propane tank with odors detectable both outside and inside the residence. Upon inspection, identified the source of the leak and shut off the valve at the tank to prevent further gas discharge. Visual examination of the gas line connections to appliance revealed proper installation of flexible yellow gas line with appropriate shutoff valve, though remediation of the tank leak will require follow-up service.

Responded to callback regarding electrical issues that began after initial installation. Performed airflow testing using anemometer at floor registers, confirming 55 CFM delivery. Accessed American Standard thermostat settings and verified proper configuration of single-stage cooling with two-stage gas/oil heating system. Collected remaining balance from original installation.

Cleared severe clog in kitchen sink drain system. Disassembled P-trap assembly showing mineral buildup and removed accumulated debris. Cleaned components thoroughly and reassembled plumbing to restore proper drainage function.

Completed follow-up installation of complete HVAC system sold by JonDZ. Verified proper leveling of all components to ensure optimal system performance and longevity.

Completed routine membership inspection of State ProLine water heater system. Visually inspected all components including supply/return lines, expansion tank, and electrical connections. All equipment appears to be functioning properly with no leaks or issues detected.

Responded to service call for Katherine Eiselsberg regarding water in basement from humidifier and gas odor concerns. Upon inspection, identified condensate pump malfunction on furnace unit causing water leakage. Performed gas leak detection test, tightened loose gas line fitting to eliminate odor. Replaced faulty condensate pump and confirmed proper drainage system operation.

Performed assessment of 15-17 year old Lochinvar boiler system and associated plumbing components. Documented existing installation configuration including water heater, expansion tank, PEX manifold distribution system, and wall-mounted Generac unit. Comprehensive photos taken of utility room setup for estimate purposes.